20% Free Updated Passleader Cisco 642-902 Certification Dumps (71-80)

QUESTION 71
Refer to the exhibit. Which three statements are true? (Choose three.)
711

A.    On the routing table of R4, the 10.1.1.0/24 route appears as an O E2 route.
B.    On R4, the 172.16.1.0/24 route has a metric of 20.
C.    The R3 S0/0 interface should not need the no ip split-horizon eigrp 1 configuration command for the 172.16.1.0/24 route to appear in the routing table of R2 as an D EX route.
D.    The administrative distance of the 172.16.1.0/24 route in the routing table of R3 is 170.
E.    On R5, the 4.0.0.0/8 route will have an administrative distance of 120 and a hop count of 6.

Answer: ABD

QUESTION 72
What is a key benefit of using a GRE tunnel to provide connectivity between branch offices and headquarters? Select the best response.

A.    authentication, integrity checking, and confidentiality
B.    less overhead
C.    dynamic routing over the tunnel
D.    granular QoS support
E.    open standard
F.    scalability

Answer: C

QUESTION 73
Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true?
731

A.    A routing loop will occur due to mutual route redistribution occurring on R1 and R2.
B.    Suboptimal routing will occur due to mutual route redistribution occurring on R1 and R2.
C.    Additional route filtering configurations using route maps and ACLs are required on the R1 and R2 routers to prevent routing loops.
D.    R2 will not be able to redistribute the EIGRP subnets into OSPF, because R2 is missing the default seed metric for OSPF.
E.    The 10.1.1.0/24 subnet will appear as 10.0.0.0/8 in the R5 routing table.

Answer: E

QUESTION 74
You have implemented mutual route redistribution between OSPF and EIGRP on a border router. When checking the routing table on one of the OSPF routers within the OSPF routing domain, you are seeing some, but not all of the expected routes.
Which two things should you verify to troubleshoot this problem? (Choose two.)

A.    The border router is using a proper seed metric for OSPF.
B.    The border router is using a proper seed metric for EIGRP.
C.    The administrative distance is set for OSPF and EIGRP.
D.    The missing EIGRP routes are present in the routing table of the border router.
E.    The subnet keyword on the border router in the redistribute EIGRP command.

Answer: DE

QUESTION 75
Which DSL encapsulation method requires client software running on the end-user PC that is directly connected to a DSL modem? Select the best response.

A.    PPPoA
B.    PPPoE
C.    PPP
D.    L2TP
E.    ATM

Answer: B

QUESTION 76
What is the purpose of configuring the router as a PPPoE client? Select the best response.

A.    to provide VPN access over L2TP
B.    to enable PPP session from the router to the termination device at the headend for metro Ethernet connectivity
C.    for DSL connectivity and removing the need for the end-user PC to run the PPPoE client software
D.    for connecting the router to a cable modem, which bridges the Ethernet frames from the router to the cable modem termination system

Answer: C

QUESTION 77
What is the international standard for transmitting data over a cable system? Select the best response.

A.    PPPoE
B.    DOCSIS
C.    CMTS
D.    AAL5

Answer: B

QUESTION 78
Under which circumstance will a branch ISR router contain interface vlan configurations? Select the best response.

A.    performing inter-VLAN routing
B.    performing 802.1Q trunking
C.    performing ISL trunking
D.    Ethernet Switch Module installed
E.    ADSL WIC installed
F.    running Call Manager Express

Answer: D

QUESTION 79
Refer to the exhibit. You want to use all the routes in the EIGRP topology for IP load balancing. Which two EIGRP subcommands would you use to accomplish this goal? (Choose two.)
791
A.    traffic-share balanced
B.    distance
C.    maximum-paths
D.    default-network
E.    variance

Answer: CE

QUESTION 80
Refer to the exhibit. R1 accesses the Internet using E0/0. You have been asked to configure R1 so that a default route is generated to its downstream devices (191.0.0.1 and 192.0.0.1).
Which commands would create this configuration?
801

A.    router eigrp 190
   redistribute static !
ip route 0.0.0.0 0.0.0.0 Null0
B.    ip default-network 20.0.0.0
C.    router eigrp 190
   redistribute static
!
ip route 0.0.0.0 255.255.255.255 Null0
D.    ip default-network 20.20.20.0

Answer: A

20% Free Updated Passleader Cisco 642-902 Certification Dumps