QUESTION 211
Study the configuration presented in the exhibit carefully. What is the objective of the route map named test?
A. marks all prefixes received from the 10.1.1.1 neighbor with a MED of 200
B. marks the 10.0.0.0/8 prefix received from the 10.1.1.1 neighbor with a MED of 200
C. marks the 10.0.0.0/8 prefix advertised to the 10.1.1.1 neighbor with a MED of 200
D. marks all prefixes advertised to the 10.1.1.1 neighbor with a MED of 200
Answer: C
QUESTION 212
EIGRP has been configured to operate over Frame Relay multipoint connections. What should the bandwidth command be set to?
A. the CIR rate of the lowest speed connection multiplied by the number of circuits
B. the CIR rate of the lowest speed connection
C. the CIR rate of the highest speed connection
D. the sum of all the CIRs divided by the number of connections
Answer: A
QUESTION 213
Refer to the exhibit. Routers RTA and RTB are running BGP but the session is active. What command needs to be added to establish the BGP session?
A. ip route 10.10.10.1 255.255.255.255 s0/0 ip route 10.10.10.1 255.255.255.255 s0/1
B. network 10.10.10.0
C. neighbor 10.10.10.1 next-hop-self
D. no synchronization
Answer: A
QUESTION 214
The following exhibit shows ipv6 route output. What would the metric be for a summary route that summarizes all three OSPFv3 routes displayed?
A. 160
B. 140
C. 120
D. 100
Answer: D
QUESTION 215
Refer to the exhibit. Router R1 is connected to networks 172.16.1.0 /26 and 172.16.1.64 /27. On the basis of the partial output in the exhibit, which statement is true?
A. Router R1 will advertise both routes.
B. Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to be advertised.
C. Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be advertised.
D. Router R1 should be reconfigured with an ACL instead of an ip prefix-list command.
Answer: C
QUESTION 216
Refer to the exhibit. Based on the output from the show command on RT1 which statement is true?
A. OSPFv3 uses global IPv6 addresses to establish neighbor adjacencies.
B. RT1 has a subnet mask of 64 bits.
C. RT1 has FastEthernet0/0 set as a DR for network type broadcast.
D. OSPFv3 uses Link-local addresses to establish neighbor adjacencies.
E. RT1 does not have a global IPv6 address set on FastEthernet0/0.
F. OSPFv3 uses IPv4 addresses to establish neighbor adjacencies.
Answer: D
QUESTION 217
Refer to the exhibit. What must be done on router RTA to ensure that EIGRP works effectively in a Frame Relay multipoint environment?
A. Issue the command bandwidth 56 on each subinterface.
B. Issue the command bandwidth 224 on each subinterface.
C. Issue the command bandwidth 56 on the physical interface.
D. Issue the command bandwidth 224 on the physical interface.
Answer: D
QUESTION 218
Based on the exhibited output, which three statements are true? (Choose three.)
A. R1 is configured with the ip summary-address command.
B. The route to 10.2.0.0/16 was redistributed into EIGRP.
C. R1 is configured with the variance command.
D. A default route has been redistributed into the EIGRP autonomous system.
E. The router at 10.1.1.2 is configured with the ip default-network 0.0.0.0 command.
F. R1 is sourcing an external EIGRP route from Null0.
Answer: ACD
QUESTION 219
After DUAL calculations, a router has identified a successor route, but no routes have qualified as a feasible successor. In the event that the current successor goes down, what process will EIGRP use in the selection of a new successor?
A. EIGRP will find the interface with the lowest MAC address
B. The route will transition to the active state
C. The route will transition to the passive state
D. EIGRP will automatically use the route with the lowest feasible distance(FD)
E. EIGRP will automatically use the route with the lowest advertised distance(AD)
Answer: B
QUESTION 220
Which three statements about the EIGRP routing protocol are true?(Choose three)
A. EIGRP sends periodic hello packets to the multicast IP address 224.0.0.9
B. EIGRP sends periodic hello packets to the multicast IP address 224.0.0.10
C. EIGRP supports five generic packet types. Including hello, update, query, reply, and ACK packets
D. EIGRP supports five generic packet types. Including hello, database description(DBD), Link-state request(LSR), link-state update(LSU), and LSAck
E. EIGRP will form a neighbor relationship with another peer even when their K values are mismatched.
F. EIGRP will not form a neighbor relationship with another peer even when their K values are mismatched.
Answer: BCF
20% Free Updated Passleader Cisco 642-902 Certification Dumps
